4 Defibrillators with pacing and cardiac monitoring capacity


SPO2 - Pulse Oximetry
Advisory Mode
External electrode adapters.

7.9"H x 11.8"W x 15.6"L
20cm x 30cm x 39.7cm

24 lbs. / 10.9kg


Type:   Rechargeable, sealed lead-acid battery.  4 Ah, 12 V nominal.
Charge Time:  2 hours to 90% of full capacity.  18 hours to 100% capacity.  Repeated charging to less than 100% will reduce the useful life of the battery.
Capacity:  2.5 hours monitoring or 50 full-energy discharges or 1 hour monitoring and recording.
AC input:   100 to 230 VAC +/- 15%, 50Hz. 
Battery Indicators:  Illuminated LED indicates battery is charging. Low Battery message appears on the monitor.


Waveform:  damped sinusoidal.
Output energy (delivered): 2,3,5,7,10,20,30,50,70,100,150,200,300, and 360 joules.
Charge control:  push-button on apex paddle and on front panel.
Charge time:  less than 5 seconds to 360 joules with a functional battery installed.
Charge done indicator:  display indicates available energy, charge-done light on apex paddle, charge done tone. Synchronizer: SYNC message appears on the monitor and is annoted periodically on the recorder while in synchronous mode. An audible beep sounds with each detected R-wave, while a marker on the monitor and sync mark on the recorder strip indicate the discharge point. Paddles: standard paddles are anterior / anterior. Adult electrodes (83 cm sq) slide off to expose pediatric electrodes (21 cm sq). Paddle cord is 10 feet (3m). Full range of internal paddles are available.


Input: ECG activity may be viewed through the paddles or patient cable.
Lead fault: LEADS OFF message and dashed baseline appear on the monitor if a lead becomes disconnected. Common mode rejection: greater than 100dB measured as per AAMI standards for cardiac monitors.
Heart rate display: digital read out on monitor from 20 to 280 bpm.

Annotations: time, date, heart rate, event markers, ECG mode, and selected energy.
Recorder Mode: automatically documents events and ECG during defibrillation episodes. The recorder can be configured to run in either real time or with a 6-second delay.
Frequency response: .5 to 40Hz monitor bandwidth. .05 to 150 Hz diagnostic bandwidth is selectable.